GWR 80225 Ballast Wagon
|GWRGreat Western Railway 80225 Ballast Wagon|
80225 at Arley
|Built By||GWRGreat Western Railway Swindon|
|Type||4-wheel ballast wagon|
|Telegraphic code||STARFISH (BRBritish Rail or British Railways)|
|1973||Arrived on SVRSevern Valley RailwaySVRA:Severn Valley Railway AssociationSVRS:Severn Valley Railway Society|
|1985||Appeared on the main line|
80225 is a GWRGreat Western Railway 10T all-steel dropside ballast wagon built in Swindon in 1937 to diagram P15. The 'new generation' ballast wagons of this type began in 1935 with Diagram P15, which had an increased length over earlier designs of 16ft 6in over the headstocks while retaining a 9ft wheelbase. The internal height of 1ft 10in gave a nominal 8 cubic yard capacity. The GWRGreat Western Railway did not allocate telegraphic codes to DepartmentalRolling stock used for the railway’s own functions (engineering etc.) rather than for general passenger or goods traffic. wagons of this type, although it was later classified as a STARFISH by BRBritish Rail or British Railways.
Unusually, the wagon has two spoked wheels of 1922 vintage and two disk wheels of the correct 1937 design.
80225 arrived on the SVRSevern Valley RailwaySVRA:Severn Valley Railway AssociationSVRS:Severn Valley Railway Society from Swindon on 17 November 1973 along with 80603, having been acquired by SVR(H) for permanent way work. It is also a sister to 80684. In addition 60906 is an earlier version and 30903 a later development, built to diagrams P14 and P18 respectively.
Restoration of 80225 began in May 1981, which required the fitting of four new axle box castings to replace those damaged by the drop sides falling on them. The springs onto which the sides drop when opened were returned to their original position 3 inches further out from the centre line of the wagon to prevent this damage recurring. The wheels were cleaned down to bare metal and painted, and new oil seals were fitted. Three of the four steel floor panels were replaced. After riveting the floor, the wagon was repainted in GWRGreat Western Railway Engineers livery of black with white lettering. 80225 was returned to the P.WayPermanent Way Dept. in November 1981.
80225 required a further overhaul in 2002, the floor having been corroded by loco ash. A new thicker floor was installed, welded rather than riveted, and new riveted wagon ends were also fitted. More damage to the axle boxes was found and repaired, with new door stop springs being fitted in a further attempt to prevent damage. The wagon was again repainted in GWRGreat Western Railway Engineers livery.
- Atkins, Beard & Tourret (2013) pp. 319-320
- SVRSevern Valley RailwaySVRA:Severn Valley Railway AssociationSVRS:Severn Valley Railway Society Stock Book Ninth Edition
- SVRSevern Valley RailwaySVRA:Severn Valley Railway AssociationSVRS:Severn Valley Railway Society News 66